Evolution RAGE5-S - THE BLADE GUARD; Attachment and Operation Check; THE RIP FENCE; Attaching Rip Fence Components

17
www.evolutionpowertools.com
THE BLADE GUARD
The Blade Guard labelled 9 must be attached to the machines
riving knife.
Note: The machine should never be used without this guard in
its service position.
WARNING:
The machine must be disconnected from the
mains supply when installing the blade guard.
To attach the Blade Guard
• Raisethebladetoitsfullheighttofullyrevealthemachines
Riving Knife.
• Theguardslocatingpinshouldbepositionedthrough
the hole machined in the Riving Knife and the washer and
locking nut tted to one side. The blade guard must move
up and down easily and smoothly, so do not over-tighten
this nut (Fig. 17).
• Checktheoperationofthebladeguard.Ensurethatitis
working eciently and covers the crown of the blade.
• Lowerthebladealittleandrecheckthattheblade
guard operation.
• Whensatisedthatthebladeguardworksthroughout
the blades height adjustment range, check that the guard
works equally well with the blade at a bevel angle (Fig 18).
• Checkthatwhenthebladeisfullylowered,thebladeguard
is in contact with the table top.
THE RIP FENCE
This machine has a two (2) piece Rip Fence.
The Rip Fence Face Plate labelled 14 must be attached to the
Rip Fence labelled 13 using the xings E and G.
• InserttheboltsL through the holes on the LH side of the
Rip Fence and loosely tighten the nger nut G on
the RH side.
• SlidetheRipFenceFacePlateontotheRipFenceoverthe
heads of the bolts (Fig. 19).
• Tightenthetwongernuts.
To attach the Rip Fence:
• HooktherearoftheRipFenceGuideovertherearRipFence
Rail.
• Withthehandleinitsupperposition,locatethefrontofthe
Rip Fence over the front Rip Fence Rail.
• PushthehandledowntolocktheRipFencein
place (Fig. 20).
Fig. 17
Fig. 19
Fig. 18
Fig. 20