Operator Position
Description When more than 1 operator has been set from the "Total Number of LSM-VIA
Connected to the Server" on page 20 parameter (multi-operator mode), this
setting is used to select the operator number on each workstation. It must
therefore be different on each workstation.
Channels distribution:
The number of available players on the server is divided by the number of
operators. If there are more players than operators, the first operator(s) get(s)
more players.
The first operator receives the first player(s).
• Example with 4 operators in a 8IN/4OUTconfiguration: PGM1 is for Operator
1, PGM2 for Operator 2,...
• Example with 4 operators in a 6IN/6OUTconfiguration: PGM1 and PGM2 are
for Operator 1, PGM3 and PGM4 are for Operator 2, PGM5 is for Operator 3
and PGM6 is for Operator 4.
• Example with 3 operators in a 6IN/6OUTconfiguration: PGM1 and PGM2 are
for Operator 1, PGM3 and PGM4 are for Operator 2, PGM5 and PGM6 are for
Operator 3.
The selection of recorders per operator is done with the "Operator Recorders"
on page 21 parameter.
The remote buttons will automatically be mapped appropriately.
Possible Values Operator 1, Operator 2, Operator 3, Operator 4.
Default value Operator 1.
Operator Recorders
Description Allows to select the recorder channels the selected operator will be able to work
with.
Possible Values Recorder labels from A to L.
Click the recorder buttons to select (highlight) the corresponding recorder
channels.
The same recorders can be selected by several operators.
The remote buttons will automatically be mapped appropriately.
Default value No recorder selected.
INSTALLATION AND CONFIGURATION MANUAL
LSM-VIA |6. Configuring LSM-VIA| 21
To Next Page
Loading...
Need help?
General