To Next Page

To Previous Page

• The GPI connector allows GPI (General Purpose Interface) devices to send or receive

electric pulses that will trigger commands on the server or to be connected with third-

party devices.

• The VGA and Keyboard connectors allow a monitor and a keyboard to be connected

to the EVS server.

• The Audio Monitoring Output connector is a DA-15 connector that allows audio

output connections for monitoring purposes.

Power Supplies

The power supplies are located on the right of the rear panel.

The server power supply is made of two hot-swappable units. Both of these units are

connected to allow automatic power switching to the second power supply should the first

one fail.

5.3. Video Connections

You fill find full details on video connections in the Configuration manual, in the chapter

"Supported Configurations".

5.4. Audio Connections

5.4.1. Audio Channels

The XTnano server manages up to 64 embedded audio channels, depending on the

chosen variant and the installed hardware.

The embedded audio modules and codecs can be used as input or output channels for

embedded, digital (AES/EBU), or analog audio signals.

Depending on your server configuration you can find the following audio connectors on the

rear panel:

• Digital audio:

◦ DA-15 connectors: 16 inputs and 16 outputs (110 Ohm balanced).

◦ BNC connectors: 8 inputs and 8 outputs (75 Ohm unbalanced).

• Analog audio:

◦ DA-15 connectors: 16 inputs (high-Z balanced) and 16 outputs (600 Ohm drive

capable - breakout cables with XLR connectors available).

• Audio monitoring :

◦ DA-15 connector: 4 analog mono outputs (600 Ohm drive capable) .

See also section "Audio Specifications" on page 11 for full information on the available

audio hardware configurations.

The connectors are illustrated along with their respective pinouts in the following topics.

30 5. Hardware Installation and Cabling

EVS Broadcast Equipment SA Issue 12.02.A- December 2013

EVS XT nano User Manual

Other manuals for EVS XT nano