EXCELL PRECISION CO., LTD
02005159 ZSME300000350
To clear totalization data, press M+ key to let display shows up totalization numbers,
then press the
M+
|
PRINT
key again, to clear totalization data. RS232 will print out
totalization numbers, total weight, etc.
P.s. Weight must return to net zero if to perform clear function.
F
KEY (Non approval models.
Function key (In , select F key as “MC”, “HR” or “T-TP”)
Foot Switch Mode
This function is optional. Use to select TARE|PT key as “ZERO” or “PRINT” key
If “PRINT” key is set ( = 10/11), all totalization data will be printed out, and
totalization will be cleared.
If it is Brazil version and foot switch is set as Print function, it has totalization function
and print function.
Simple Counting Mode
Use UNIT key to switch unit to Pcs, to go into simple counting mode.
1. Use
NET|GROSS
key, to select a sample number from “10, 20, 50, 100, or 200”. Display
will show , , , , in an sequential order by pressing
NET
|
GROSS
key.
2. Select a sampling number, and put appropriate weight on platter, and press UNIT key.
Display will show “ ”. The scale will go into counting mode after weight is
stable, and display will show the sample number.
Unit weight insufficient ( ): Sample unit weight is less than 0.2d or total sample
weight is less than 20d (d=division)
While sampling, if there is insufficient sample or unit weight insufficient indication “”,
the scale is still usable, but there may be slight inaccuracy.
After Power-off, the scale automatically memorizes the sampling number, and it is
available when “Pcs” unit is selected next time.
If the setting is “automatic average unit weight “, if the object on platter > the previous
sampling number more than 5 pcs, and also < less than 100% the previous sampling
number, the scale will execute unit weight calibration automatically.
To Next Page
Loading...
Need help?
General
