Excell GW User Manual

EXCELL PRECISION CO., LTD
02005159 ZSME300000350
30
2-2-5 Selection of the Continuous Transmission Rate
Select in the RS232 serial interface setting mode to set the
Continuous Transmission Rate.
Continuous transmission rate setting
The LCD shows the last setting.
 Default setting:
Use ZERO or UNIT keys to select the
continuous transmission rate:
= 1 time/sec
= 2 times/sec
= 4 times/sec
= 8 times/sec
= 16 times/sec
= More than16 times/sec
Note: Actual output times vary by
hardware implements
Press TARE | PT key
Use the ZERO or UNIT keys
to select the continuous
transmission rate.
Press TARE | PT key
Key in the parameter “00”
Press TARE | PT key to exit
1 ZERO key  Upward key (0~9 digit entry)
1 UNIT key  Downward key (0~9 digit entry)
1 TARE | PT key  Move cursor rightward
1 NET | GROSS key  Move cursor leftward

Excell GW Specifications

General

Brand	Excell
Model	GW
Category	Indicator system
Language	English