24 FOT-930
Setting Autonaming Scheme
Setting Autonaming Scheme
Initially, the unit suggests cable and fiber names based on autonaming
settings. After saving a result, the unit prepares the next fiber name by
incrementing the suffix (or by adding “001” to a name with no suffix).
When you manually change the name for the first time (in Power Meter,
ORL Meter or F
ASTEST ), the unit then ignores autonaming settings.
Cable names: maximum 21 characters for prefix, 3 digits for number
(or 24 characters when name is manually set)
Fiber names: maximum 12 characters for prefix, plus 3-digit suffix
(duplicate names allowed when name is manually set)
Note: If you manually change a fiber name, then turn the unit off without saving
at least one result, this name will be discarded.
IMPORTANT
To start using new autonaming settings, you must delete all cables
from memory.
To Next Page
Loading...
