Communicating with Other Users
Multifunction Loss Tester 67
Sending and Receiving Text Messages
3. Ensure that the port indicated (SM or MM) is the one you use.
Otherwise, press Port Setup (F1/F2 key) and change it, then return to
the Messages pane.
4. Using the up/down arrows, scroll through the list and select the
message.
5. Press Send (F1/F2 key).
After a few seconds, your message will automatically appear on the
receiving unit. If an incompatible unit (or no unit) is detected at the other
end, or if the F
ASTEST port of the receiving unit is in use, an error message
will appear.
When you receive a message:
Your unit emits a short beep and displays the received message.
Press OK to clear the display and return to your previous function.
Press Reply to access the Messages pane and reply to the message.
You will then need to use the menu to return to your previous function.
However, your last readings will be lost.
Note: If the message was written with a language not supported by your unit, you
will see unreadable characters only.
To Next Page
Loading...
