Exmark LAZER Z - Motion Control Full Forward Tracking Adjustment; Caster Pivot and Gauge Wheel Pivot Bearings Pre-Load Adjustment

Maintenance
MotionControlFullForward
TrackingAdjustment
Ifthemachinetravelsorpullstoonesidewhenthe
motioncontrolleversareinthefullforwardposition,
adjustthecoverplates.
1.Loosenthescrewsonacoverplate(seeFigure61).
2.Slidethecoverplatebackwardorforwardto
adjustthetraveloftheleverandtightenthe
screws.
3.Drivethemachineandcheckthefullforward
tracking.
4.Repeatsteps1through3untildesiredtracking
isobtained.
g010015
Figure61
RHMotionControlShown
1.Screw
3.Motioncontrollever
2.Coverplate
CasterPivotandGauge
WheelPivotBearings
Pre-LoadAdjustment
Removedustcapfromcasterandtightennylocnut
untilwashersareatandbackoff1/4ofaturn
toproperlysetthepre-loadonthebearings.If
disassembled,makesurethespringdiscwashersare
reinstalledasshowninFigure62.
g006131
Figure62
AllModelsExceptWingDeck
1.Springdiscwashers
g228558
Figure63
WingDeckModels
1.Springdiscwashers
74