(Note: ‘Auto Set by DHCP’ is preferred to be set to ‘ON’ if controller is connected to LAN that where a
DHCP server is available)
Wireless Network Configuration
Before setup the wired network, you shall check the LTE modem is properly installed.
- Antenna is well mounted
- A valid(supported by the modem) SIM card is installed
Figure 10. LTE Modem Installation
Attention: Different country’s LTE mode is different, so before using this function, please connect the charger’s
service point to get more detail information.
And the local LTE NET quality and the local LTE signal quality will deeply impact this application.
Setup APN
Normally you shall get the APN related information (APN/User/Password) from your sim card supplier and input it
into the parameters (some SIM card can be automatically recognized so that you can skip these settings)
Following is an example of configuration:
To Next Page
Loading...