Explo X2 Wave Flamer - Attachment 2: Troubleshooting Guide

ATTACHMENT 2 - TROUBLESHOOTING
Problem
Possible cause
Possible solution
Wave Flamer doesn't ignite.
Dirty ignition electrode
Clean electrodes with toothbrush
Defective ignition electrode
Check electrode for any obvious damages. (If damaged – Contact manufacturer)
Damaged ignition electrode cable.
Check isolation of ignition electrode cables. ( If damaged – Contact manufacturer)
Other (eg. internal damages to the system)
Contact manufacturer
Fluid unsuitable for temperatures
Consult MSDS of the fluid and check temperature range.
Wrongly mounted ignition electrode
Adjust according to attachment 3.
Clogged nozzle
Dismount nozzle and clean with clear fluid and pressurized air.
Wave Flamer is leaking.
Internal problem
Open side panel, build pressure and find weak spot. Contact manufacturer.
Wave Flamer head is leaking.
Pivot joint leaks
Contact manufacturer. Shipment of spare parts possible.
Nozzle leaks
Change rubber sealing ring.
Wave Flamer resets.
Power supply inadequate
Check power supply (max. power per Wave Flamer is 350W).
Defective mains supply
Contact manufacturer
Wave Flamer doesn't pump.
Defective pump
Contact manufacturer .
Reflux valve jammed
Contact manufacturer (Guide to cleaning the valve possible).
Wave Flamer pumps continuously.
Defective reflux valve
Contact manufacturer .
Wave Flamer head doesn't move.
Defective motor
Contact manufacturer .
Wave Flamer can't be controlled.
Wrong settings
Check usage mode and system settings. Consult manual.
Defektive radio module
Contact manufacturer .
Defektive DMX controller or DMX cable
Check DMX hardware.
Display shows an error-code.
System error
Contact manufacturer .
Wave Flamer can't be switched on.
Problem with the power supply
Check supply line (eg damage to power cable or the fuze).
Internal problem
Contact manufacturer .