Need help?Do you have a question about the Explo X2 Wave Flamer and is the answer not in the manual?
Describes the primary function and operation of the X2 Wave Flamer effect device.
Outlines the various applications and potential uses for the X2 Wave Flamer.
Details the components visible on the front panel of the standard X2 Wave Flamer model.
Details the components visible on the top of the standard X2 Wave Flamer model.
Details the components on the front panel of the Head variant without an internal pumping unit.
Details the components visible on the side of the Head variant without an internal pumping unit.
Key Switch, Display, LEDs, Antenna Socket, Programming Socket, DMX Connectors, ON/OFF Switch, Fuses, Power Connector, Swivel Head, Fluid Canister, Lead Through, Level Indicator, External Pump Connector.
ID/Box Number, Pressure, Mains Supply, Type/Showname, Check/Lines, Sec-Key/Frequency, Power/Timeout, Position Min/Max, View AutoShow, Edit Wave Flamer, Edit DMX, Systemtest, Pump/Vent, Software Version, Group BOX.
Mode, Box, Sec-Key, Frequency, Power, Timeout, Lock, Sys, Pos 1-15/16-30 Igntime, Pos 1-15/16-30 20ms, Center, Invert, Pos Min/Max, Restore Default, Demo Mode, Radio Prog, GroupBOX, Pump, Pressure.
Modus, Startadresse, Customer, CH5 Vers., Protocol, DMX EASY.
Defines the 'audience side' of the projector and its implications for positioning.
Explains the different positional definitions and angles for device operation.
Provides instructions and recommendations for safely positioning the devices.
Outlines the necessary power supply specifications and connection methods for the devices.
Lists essential checks and preparations before conducting a show.
Details the steps required to activate the X2 Wave Flamer device.
Explains the correct procedure for safely switching off the X2 Wave Flamer.
Guides on preparing the device for manual control via radio signals.
Details how to prepare the device for automated ignition sequences via radio.
Instructions for setting up and using the ShowCreator software for shows.
Explains how to synchronize ignition cues with music and timing.
Guides on assigning specific effects to programmed ignition cues.
Describes how to define and use group boxes for controlling multiple devices.
Details the process of creating, managing, and using groups within ShowCreator.
Explains how to adjust the timing for ignitions and sequences in shows.
Provides guidance on calculating the necessary drive time between ignitions for synchronization.
Outlines the procedure for transferring created shows to the transmitter and devices.
Guides on setting up the device for control using DMX 512 protocol.
Angle, Speed, Ignition, Opening Time, Programm, Mode.
Explains the process of triggering ignitions using DMX commands.
Guides on setting up the device for simplified control using Easy-DMX.
Mode, Single Ignition/Sequence.
Describes the optional mechanical angle blockers for enhanced safety.
Double Solenoid Valve, Watchdog-Timer, Mechanical Block, Auto Safety Checks, Deactivating Outer Angles, Arming Device, Power Outage.
Emergency Shut Off, Drip Pan, Interrupting AutoShow.
Offers practical safety advice for using and maintaining the device.
Frontal View, Top View.
Lists all predefined single ignition sequences with their parameters.
Lists all predefined stepp sequences with their parameters.
Lists all predefined wave sequences with their parameters.
Lists additional sequences, including those for DMX control.
General| Brand | Explo |
|---|---|
| Model | X2 Wave Flamer |
| Category | DJ Equipment |
| Language | English |
To Next Page