Most of the time, Scenes are added to Wave Flamer shows,
where all devices, regardless of box number, should create
the same effect simultaniously. Using a group box can save
you lots of valuable programming time.
10.6 DESIGNATING AND USING GROUPS IN THE SHOWCREATOR
The ShowCreator 4.12 Beta 40 allows for the designation of groups, that can be copied and / or be
moved at the same time. This means you don't need to add every sequence or single ignition for every
Wave Flamer one at a time.
The function of the group is shown in the following example. Baseline is a show with three X2 Wave
Flamers (box 1, 2 and 3). In the following pictures, a part of the show is shown, into which a
simultanious ignition of all three boxes at the same ignition time has been added:
To Next Page
Loading...