12
MONROC
INSTALLATION
TRANSPORT
Positioning
Packaging
Delivery inspection
Install the machine on a level surface. Adjust the feet to
ensure that it dispenses coffee evenly in all of the cups.
Select a level, dry, strong and stable installation surface
at least 110 cm off the floor.
Leave enough space above and behind the machine to
ensure easy cleaning and maintenance.
Do not install the machine whilst wet or damp. If wet or
damp, leave the machine until completely dry then ask
service personnel to check that none of the electrical
components are affected.
Note:
Leave an air gap of approximately 30 cm above
the machine and 10 cm behind it to ensure
ventilation.
i
MIN. 10 cm
MIN. 30 cm
The machine is shipped in a unique carton box which uses expanded polystyrene paddings.
The machine box is provided with conventional symbols that can be perfectly visible during the
handling and storage tasks.
The machine box must stay in a vertical position during the transport. Do not tip or try to place
the box tilted sideways in any way.
During transportation the box must be protected from hits, impacts, shocks and exposure of bad
weather elements.
After the delivery, check that the machine is in the exact condition described in the documentation
of the transport, accessories included.
Check that the machine does not have any damage caused by transportation. If this happens, inform
to the shipper and the distributor of the machine.
The packaging materials are potentially dangerous and should be kept away from children.
Make sure to leave the materials of the box and packaging at a suitable recycling center.
To Next Page
Loading...
Need help?
General
