Expobar New Elegance - Programming Dosage of the Control Panel

15.
8.2. Programming dosage of the control panel
Here we will program the volume of the coffee doses that will be automatically brewed by each
selection on the keypad.
• Keeppressedover8secondsthebuttonofcontinuouscoffee:allthelightsinthekeypad
 willlight,butthelightofthecontinuouscoffeewillash.
• Within5secondspressthebuttonofthecoffeeselectiontobere-programmed
 (1shortespresso-1longespresso–2shortespressos–2longespressos).
Notice that all the lights will switch off, except the one of the option selected and the one of
continuous brewing.
• Thegroupbeginsbrewingtheespresso.Whenthedesiredvolumeofespressobrewedis
reached, press again the selection, and this volume will be stored as the programmed
dosis.
• Repeattheprocesswithalltheotherselectionsthatneedre-programming.
Whenever we have reprogrammed each selection, its corresponding light will come off.
Each dosis re-programming must be done with freshly grinded coffee, each time.
In case only one of the selections is to be reprogrammed, act as previously described,
re-programming only the one desired; remaining buttons will keep the existing
programmed dosis.
Very important:
When you re-program any dosis in the left keypad (facing to the machine),
this dosis will be stored in every other keypad.
This is: If for example we modify
the dosis of the 1 short espresso in the left keypad, automatically this newly memorized
new dosis will be stored in all the other keypads.
This only happens with the left keypad; if we modify the dosis on any other, it will not
overwrite any other.
8. ELECTRONIC CONTROL PANEL New Elegance