PRODUCT FUNCTIONALITY
20
Chapter 6
RECOMMENDATIONS BEFORE IGNITION
Before ignition the following points must be veri ed:
the feed-box must be full of pellets
the combustion chamber must be clean
The brazier must be completely free and clean
check the hermetic closure of the re door and the ash drawer
make sure the power supply cable is connected correctly
the bipolar switch in the rear right part must be positioned on 1
ATTENTION!!!
Do not use any in ammable liquids for ignition
Do not allow the bag of pellets to come into contact with the boiling hot stove during the
lling phase
In the case of continuous no ignition, contact an authorised technician
IT IS PROHIBITED to burn non-pelletised raw materials inside our stoves.
The failure to comply with these prescriptions voids all guarantees and could jeopardise the
safety of the appliance.
The lid of the pellet container must always be closed. It must only be opened during the fuel
loading phase.
It is recommended that the feed-box is always half full.
During the lling phase do not allow the bag of pellets to come into contact with the
product
The bags of pellets must be kept at least 1.5 metres from the stove.
IGNITION
A. Press key 1 for 3 seconds.
Once time for ignition has passed (which can vary depending on the model) if the machine has not ignited,
the “no ignition” alarm occurs.
In the case of alarm due to no ignition, follow these points:
1. Wait a minimum of 10 minutes without pressing any button on the display, in the mean time clean the
brazier.
ATTENTION!
N.B. DO NOT PUT THE PELLETS BACK IN THE TANK FROM THE BRAZIER
2.Close the door
3.Press key 1 for 3 seconds.
If ignition takes place, the machine will automatically go into the third phase: start-up.
The passing from ignition phase to start-up is fully automatic.
N.B. As times are variable, there are no precise or de ned times.
To Next Page
Loading...
