Extraflame Elisir - Chapter 8 THE REMOTE CONTROL

THE REMOTE CONTROL
24
Chapter 8
THE REMOTE CONTROL
The heating power, the wanted room temperature (or set water in case of thermoproduct) and the auto-
matic appliance ignition/switch o , can be adjusted using the remote control.
S = Indicator light indicating the pressing of every
key.
Display keys correspondence with remote control keys
1 = p3+p5
2 = p2
3 = p3
4 = p4
5 = p5
S
Open by pressing the point indicated in the  gure
P3
P2
P4
P5
 gure 8.1
 gure 8.2  gure 8.3
To switch on the stove, simultaneously press buttons 3 and 5 for 1 second; the appliance will automatically
enter the ignition phase. The start phase will follow allowing the stove to develop and adjust the  ame.
Once start phase is completed, the appliance enters normal functioning: it is possible to adjust the heating
power by using buttons 4 and 5, whereas the wanted temperature can be adjusted using buttons 2 and
3.
To switch o the stove simultaneously press buttons 3 and 5 for three seconds; display D1 will show
“OFF”.
The remote control works with a MN21 12volt type battery (like open gates remote controls).
To replace the batteries open rear part lid as shown in the  gures below.