Hardware Mounting and Installation
AP-7562 Installation Guide 30
6 Rotate the Access Point bracket upward and align the top holes on the sides with the
top holes on the angle adapter bracket. Insert two M6 hex flange screws into the top
holes on the angle adapter bracket. Use a torque wrench, or a ratchet and a 10mm
socket, or an adjustable wrench, to finish attaching the Access Point bracket to the angle
adapter bracket with the M6 hex flange screws in the open slot connections and the top
holes on the angle adapter bracket. Do not tighten the screws until all rotation and tilt
adjustments are complete.
7 To adjust the position of the Access Point, rotate the Access Point bracket (plus or minus
15 de
grees) and tilt the angle adapter bracket (up to 45 degrees).
8 Tighten all hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit:
1 Attach the pole mount at the desired mounting location using a U-bolt or band clamps.
2 Complete the steps for assembling and positioning the mounting bracket sections for
poles less than or greater than 3 inches. See <bl_blue><em_Emphasis>Vertical Pole Mount on page 24.
3 Attach the extension arm to the bracket (with f
our M6 hex flange screws) using a torque
wrench, a ratchet and a 10mm socket or an adjustable wrench. The two oval holes must
To Next Page
Loading...
