Summit WM Controller, Access Points, and Software Solution
Summit WM Getting Started Guide, Software Version 5.120
Summit WM200/2000 Controller LEDs
The Summit WM200/2000 Controller has five LED lights and two switches on its front panel.
Figure 7: Summit WM200/2000 Controller’s LED lights and switches
The description of the LED states and switches is provided below:
● Reset Switch – Reboots the system.
● RUN LED – Indicates the CPU’s initialization has completed and the system is ready to provide
application level services.
● ACT LED – Indicates the system’s software is in active running state.
● WARNING/ERROR LEDs – Indicate a problem in the running state of the system.
● Whenever either of the alarm LEDs is lit, the seven-segment display provides the corresponding
code point for the error indication. When the system is fully active and running, the console
displays the letter A as seen in Figure 7.
● LCT Switch – The LCT button is used during the manufacturing process and is inactive otherwise.
● INT LED – Not used in the current release.
Summit WM200/2000 Controller’s LED states and Seven Segment Display (SSD)
codes
Firmware initialization
:
Table 1: LED states and SSD codes during firmware initialization
Active LED Warning LED Error LED SSD Codes Condition
Green 0 The processor has started; and the firmware has
taken control.
Green 3 The Host Supervisory Card has failed to download
Bootloader from Flash.
Green 4 The system is checking firmware consistency.
Reset
Switch
WARNING
LED
ERROR
LED
INT LED
LCT Switch
RUN
LED
ACT LED
Seven-Segment
Display
To Next Page
Loading...
