Summit WM Getting Started Guide, Software Version 5.1 35
2 Summit WM Controller configuration
This chapter explains how to configure the Summit WM Controller’s settings to make it operational.
The topics in this chapter are organized as follows:
● Accessing the Summit WM Controller for the first time
● Connecting the Summit WM Controller to the enterprise network
● Changing the administrator password
● Configuring the network time
● Applying a license key
Accessing the Summit WM Controller for the first time
You can access the Summit WM Controller by using a laptop computer with a Web browser.
To access the Summit WM Controller using a web-enabled laptop:
1 Connect the Summit WM Controller’s management port to the web-enabled laptop computer with a
cross-over RJ 45 Ethernet cable.
NOTE
The IP address of the Summit WM Controller’s management port is 192.168.10.1.
2 Statically assign an unused IP address in the 192.168.10.0/24 subnet for the Ethernet port of the
laptop computer.
You can use any IP address from 192.168.10.2 to 192.168.10.254.
3 Launch your web browser.
To Next Page
Loading...
