Summit WM Getting Started Guide, Software Version 5.1 75
AP is in the pending state, it receives minimum configuration that only allows it to maintain an active
link with the Summit WM Controller for future state change.
To manually approve pending Wireless APs:
1 From the main menu, click Altitude APs. The Altitude AP screen is displayed
2 In the left pane, click Access Approval. The Access Approval screen is displayed.
3 In the Select Altitude APs section, click Pending. The pending Wireless APs are selected.
4 In the Perform action on selected Wireless APs, click Approved. The state of the selected Wireless
APs is changed from “Pending” to “Approved”.
Assigning names to Wireless APs
After the Wireless APs are successfully registered, you can assign them appropriate names.
To assign a name to a Wireless AP:
1 From the main menu, click Altitude APs. The Altitude AP screen is displayed.
2 In the Altitude APs list, click the Wireless AP for which you want to assign a name. The AP
Properties tab is displayed.
3 In the Name text box, type the name that you want to assign to the selected Wireless AP.
4 To save your changes, click Save.
NOTE
You can modify the Wireless AP’s properties that are displayed in the right pane of the Altitude AP screen. For more
information, see “Modifying Wireless APs’ properties” on page 76.
To Next Page
Loading...
