Summit WM Getting Started Guide, Software Version 5.1 51
Confirming the ports are set for OSPF
To confirm the ports are set for OSPF:
1 From the main menu, click Summit Controller. The Summit Controller screen is displayed.
2 On the Routing Protocols screen, click View Forwarding Table. The Forwarding Table is displayed.
3 Click the OSPF Neighbor tab.
If OSPF protocol is enabled, this report displays the current neighbors for OSPF.
4 Click the OSPF Linkstate tab.
If OSPF protocol is enabled, the report displays the link state advertisement (LSAs) received by the
running OSPF protocol.
5 To update the screen, click Refresh.
Now you should configure the DHCP, DNS and RADIUS servers on the network.
The following chapter explains how to configure DHCP, DNS and IAS services on Windows 2003
Server.
To Next Page
Loading...
