Extreme Networks Summit WM - Outdoor AP LED Status

Summit WM Getting Started Guide, Software Version 5.1 87
Outdoor AP LED status
The following figure depicts the location of the LEDs on the Outdoor AP.
Figure 20: Outdoor AP LEDs
NOTE
Although Figure 5 depicts six LEDS, only R1, R2 and F LEDs are used in the current release. The remaining LEDs
are disabled.
The Center, Left and the Right LEDs work in conjunction to indicate the general, high-level state and
the detailed state respectively.
The following table provides a composite view of the three LED lights of the Outdoor AP’s state.
Table 11: Outdoor AP LED status
R1 LED R2 LED F LED Outdoor AP’s detailed status
Off Off Blinking Red Initialization: Power-on-self test (POST)
Blinking
Green
Blinking Red Initialization: Random delay
Solid Green Blinking Red Initialization: Vulnerable Period
Solid Red Reset to factory defaults
Solid Green Blink Red WDS scanning
Blinking
Green/
Yellow
Off Blinking Red Network discovery: 802.1x authentication
Solid Red Failed 802.1x authentication
Blinking
Green/Yellow
Blinking Red Network discovery: DHCP
Solid Red Default IP address
Solid Green/
Yellow
Blinking Red Network discovery: WM discovery/connect
Solid Red Discovery failed
Solid
Green
Off Blinking Red Connecting with WM: Registration
Solid Red Registration failed