Summit WM Getting Started Guide, Software Version 5.1 47
4 Routing Configuration
This chapter explains how to configure static routing and OSPF routing on the Summit WM Controller.
The topics in this chapter are organized as follows:
● Configuring a static route
● Configuring the OSPF routing
Configuring a static route
To configure a static route:
1 From the main menu, click Summit Controller. The Summit Controller screen is displayed.
2 In the left pane, click Routing Protocols. The Routing Protocols screen is displayed.
3 To add a new route, type the destination IP address of a packet in the Destination Address text box.
To define a default static route for any unknown address not in the routing table, type
0.0.0.0.
This is also called as defining the default gateway.
4 Type the appropriate subnet mask in the Subnet Mask text box to separate the network portion from
the host portion of the IP address (typically 255.255.255.0).
To define a default static route for any unknown address, type
0.0.0.0.
5 Type the IP address of the specific router port or gateway that serves as the next-hop for the packets
from Summit WM Controller gateway).
This router port (or gateway) must be on the same subnet as the Summit WM Controller.
6 Click Add. The new route is added to the list of routes.
To Next Page
Loading...
