Extreme Networks Summit WM - Viewing the Forwarding Table; Configuring the OSPF Routing

Routing Configuration
Summit WM Getting Started Guide, Software Version 5.148
7 Select the Override dynamic routes check box to give priority over the OSPF routes that the Summit
WM Controller uses for routing.
By default, the Override dynamic routes is enabled. If you want to remove priority for static routes
so that the routing is always controlled dynamically, clear the Override dynamic routes check box.
8 To save your changes, click Save.
Viewing the forwarding table
You can view the defined routes, whether static or OSPF, and their current status in the forwarding
table.
To view the forwarding table:
1 From the main menu, click Reports. The Reports & Displays screen is displayed.
2 Click Forwarding Table. The Forwarding Table is displayed.
3 To update the display, click Refresh.
Configuring the OSPF routing
To configure the OSPF routing, you must:
● Define one data port as a router port on the IP addresses screen.
● Enable OSPF globally on the Summit WM Controller. For more information, see “Enabling OSPF
globally on the Summit WM Controller” on page 49.