PRODUCT GUIDE: EYEDRO ELECTRICITY MONITORING PRODUCTS
©2011-2023 Eyedro Green Solutions Inc. Page | 24
Important note: If the setup is not successful, the device will recreate its own network and
reappear in your available network list. Your device must be connected to the internet before
you will be able to claim it on your MyEyedro Account.
TIPS
When applying power to the device it will run through its startup tests. Approximately 10 seconds after
power has been applied, the status lights will indicate the status of the communication:
• Red/Green (both) toggle 2 seconds on/off = Not connected.
o SSID, “Eyedro [xxx-yyyyy]”, should be visible in your available Wi-Fi network list.
• Green toggle 2 seconds on/off = Connected.
o Device is connected to the provisioned network and should appear as ‘Active’ in
MyEyedro.
If the status lights are still not green (connected) after following the procedure, cycle power to the Eyedro
device and try the procedure again – carefully following all instructions and notes.
Wi-Fi connection videos can be found online at the following links:
Eyedro Wi-Fi connection setup via Desktop: video link
Eyedro Wi-Fi connection setup via mobile: video link
Additional tips and troubleshooting advice can be found online at:
Website: eyedro.com
Support: eyedro.com/support
How To: https://eyedro.com/how-to-connect-an-eyefi-to-the-internet/
Troubleshooting: eyedro.com/support-troubleshooting
To Next Page
Loading...
