EZ-ACCESS PATHWAY 3G - 6.2. Install Ramp Handrail End Caps

Page 57 of 72
6.1.6.1. Install one 1/4” x 1” long hex washer head self-drilling screw through the hole in
the connector plate into the ramp handrail post and tighten securely (FIG. 6.6).
FIG. 6.6
6.2. INSTALL RAMP HANDRAIL END CAPS
6.2.1. Use plastic end caps when there are any remaining open ends on the handrails (FIG. 6.7).
Push them on by hand or use a rubber mallet. If necessary, use construction adhesive to
bond the cap to the ramp handrail.
FIG. 6.7