110
--silent[={on,off,yes,no,1,0}] Do not generate any
output (except error messages).
--socketname=socket path Use the given socket path
to communicate with fsavd. The default
socket path is /tmp/.fsav-<UID>, or
/tmp/.fsav-<UID>-sa, if fsav is
started with the --standalone option.
--status Show the status of the fsavd scanning
daemon and exit. If the daemon is run-
ning, the exit code is zero. Otherwise,
the exit code is non-zero.
NOTE: Usually, a scanning daemon
which is not running is not an error, as
fsav launches the daemon before the
scan by default. The daemon that was
launched by fsav exits after some idle
time. To run a permanent instance of the
scanning daemon, see fsavd(8).
--suspected-action1={none|report,rename,delet
e|remove} Primary action to take when
a suspected virus infection is found:
report only (to terminal and as an alert),
rename, or delete/remove.
--suspected-action2={none|report,rename,delet
e|remove} Secondary action to take if
the primary action fails. Parameters are
the same as for primary action.
--standalone[={on,off,yes,no,1,0}] Use the
To Next Page
Loading...