CHAPTER F 109
remove.
--riskware-action2={none|report,rename,delete
|remove} Secondary action to take if
primary action fails. Parameters are the
same as for primary action.
--scanexecutables[={on,off,yes,no,1,0}] Enable
the executable scanning. If a file has any
of user/group/other executable bits set, it
is scanned regardless of the file exten-
sion.
--scantimeout=value Set a time limit in seconds for a
single file scan or disinfection task. If
scanning or disinfecting the file takes
longer than the specified value, fsav
reports a scan error for the file.
If the value is set to 0 (default), the scan
timeout is disabled and the file is
scanned until the scan finishes (or a
scan error occurs).
--short[={on,off,yes,no,1,0}] Use the short output
format. Only the path to infected or
renamed files is shown.
--shutdown By default, fsavd does not immediately
exit after completing a file scan but
hangs around waiting for new scan
tasks. This option can be used to make
an idle fsavd exit immediately.
To Next Page
Loading...