FAAC 940SM Series - SECOND MOTOR CONTROL BOARD

21
ENGLISH ENGLISH
J1
J2
J6
J9
J3
J4 J7
MAIN
S/P
VMOT
24V
SP_DOWN
SETUP
SP_UP
DS1
J5
J8
J10
F1
F2
1 2
ON
SECOND MOTOR CONTROL BOARDSECOND MOTOR CONTROL BOARD
SECOND MOTOR CONTROL BOARDSECOND MOTOR CONTROL BOARD
SECOND MOTOR CONTROL BOARD
LED ON OFF
MAIN 220V~ mains ON 220V~ mains OFF
V MOT motor powered up motor powered down
24V + 24V ON + 24V OFF
PUSH-BUTTON MEANING
SETUP inactive
SP-DOWN inactive
SP-UP inactive
DS1 MEANING
Dip n°1 to be always positioned to OFF
Dip n°2 posizionare sempre in OFF
FUSE MEANING
F1 fuse 5x20 T 6.3A/250V (motor
protection)
F2 fuse 5x20 T 1A/250V (24V
protection)
CONNECTOR MEANING
J1 transformer 40V secondary winding
J2 connector to J1 of 940SDM
J3 connector to J2 of 940SDM
J4 transformer 24V secondary winding
J5 connector to J9 of 940SDM
J6 second motor quick-fit connector
J7 not used
J8 RS232 serial port for PC connection
J9 NOT AUS emergency stop (NC contact)
J10 connector to J3 of batteries board
S/P LED STATUS MEANING
OFF normal operating status
ON no connetting to 940SDM board
INSTINST
INSTINST
INST
ALLING SECOND MOTORALLING SECOND MOTOR
ALLING SECOND MOTORALLING SECOND MOTOR
ALLING SECOND MOTOR
BOARDBOARD
BOARDBOARD
BOARD
The assembled 940 twin-motor doors are supplied with
pre-wired second-motor board.For Kit doors, fit the
second board using the spacers provided and
positioning them on the 940SDM board to correspond
to the holes as shown in fig. 1 rif. 햲. Wire up the two units
using the cables provided and following the diagram in
fig. 2.