FAAC 950N - Page 12

950N 11 732708 - Rev. F
ENGLISH
EC DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINE
The undersigned, representing the following manufacturer :
Manufacturer : FAAC S.p.A.
Address : Via Calari ,10 - 40069 Zola Predosa BOLOGNA - ITALIA
herewith declares that to the partly completed machinery :
Description : Automated system for swing doorsf
Model : 950N
the essential requirements of the following EC directive (including all applicable amendments)
 • 2006/42/ECMachineryDirective
have been applied and fulfilled, and that the relevant technical documentation is compiled in accordance with part B
ofAnnexVIIoftheabovementionedMachineryDirective.
The above identified partly completed machinery is also in compliance with the all the relevant provisions of the
following EC directive (including all applicable amendments)
 • 2004/108/ECEMCDirective
The following harmonized standards have been applied:
o EN16005:2012
o EN61000-6-2:2005
o EN61000-6-3:2007
The above identified partly completed machinery must not be put into service until the final machinery into which it is
tobeincorporatedhasbeendeclaredinconformitywiththeprovisionsoftheabovementionedMachinery
Directive2006/42/EC.
Bologna,23-07-2013     ManagingDirector
A. Marcellan