FAAC 950N - Electrical Preparations

950N 15 732708 - Rev. F
8
8
ENGLISH
For electrical cable installation, use adequate rigid and/or flexible tubes. Always separate the
low-voltage accessories connection cables from the power supply cables. To avoid possible
interference, use separate sheathing.
5 ELECTRICAL PREPARATIONS
1. 950 N Operator
2. Monitored infrared sensors
3. Key release for external use (KEY command)
4. Emergency open/close button
5. KP-CONTROLLER programming unit (optional)
6. KP-CONTROLLER locking key switch (optional)
7. Electric lock 24V= max 0.5 A
8. Shunt box
In case of operator on-door installation, make all electrical connections using a shunt box and suitable exible
tubes/couplings, available commercially.
Fig.3
7) Assemble the sliding block d with the springs j .
8) Insert the Teon sliding block inside the track b .
9) Manually pull the arm g inward and secure the track to
the closed door using two M6 screws.
10) Insert the two lateral plugs a in the track.
11) Manually verify that the door freely opens and closes
completely and stops on the mechanical stops.