FAAC E124 - System Start-Up; Setup Procedure; Powering On the Board; Board Programming Modes

15
ENGLISH
PA
PAUSE TIME A:
Pause time following a TOTAL opening command. It has
only effect if a logic with pause time was selected. Can
be adjusted from 0 to 59 sec. in one-second steps.
Next, the viewing changes in minutes and ten seconds
(separated by a dot) and time is adjusted in 10-second
steps, up to the maximum value of 9.5 minutes.
E.g.: if the display shows 2 .5, the pause time will be 2
min. and 50 sec.
Other more detailed programming
possibilities are feasible by programming
with a PC (see dedicated instructions).
20 20 20 20 20 20
Pb
PAUSE TIME B:
Pause time following a PARTIAL opening command. It has
only effect if a logic with pause time was selected. Can
be adjusted from 0 to 59 sec. in one-second steps.
Next, the viewing changes in minutes and ten seconds
(separated by a dot) and time is adjusted in 10-second
steps, up to the maximum value of 9.5 minutes.
E.g.: if the display shows 2 .5, the pause time will be 2
min. and 50 sec.
Other more detailed programming possibilities
are feasible by PC programming (see
dedicated instructions).
20 20 20 20 20 20
F1
MOTOR 1 POWER:
Adjusts the maximum power level of motor 1.
01 = minimum power
50 = maximum power
Other more detailed programming
possibilities are feasible by programming
with a PC (see dedicated instructions).
If the power value is changed, we
advise you to execute a new SETUP (see
parag.10.1)
25 25 25 40 25 35
F2
MOTOR 2 POWER:
Adjusts the maximum power level of motor 2.
01 = minimum power
50 = maximum power
Other more detailed programming
possibilities are feasible by programming
with a PC (see dedicated instructions).
If the power value is changed, we
advise you to execute a new SETUP (see
parag.10.1)
25 25 25 40 25 35
SP
SPEED:
Adjusts the motion speed of the motors. There are 10
levels. The value is relative and not absolute, because
the speed value refers to the weight of the leaf measured
during the SETUP cycle
0 1 = minimum speed
1 0 = maximum speed
Other more detailed programming
possibilities are feasible by programming
with a PC (see dedicated instructions).
08 08 08 08 08 08
Display Function
Default 0 Default 1 Default 2 Default 3 Default 4 Default 5