What to do if my Faber e-MatriX Indoor Fireplace will not operate, the LEDs continuously blink once every eight seconds?
If your e-MatriX will not operate and the LEDs continuously blink once every eight seconds, it means the water level is too high. Remove water from the sump so that water is between the high and low water marks. Also, check the electromechanical valve in the Control box.
How to fix the flame effect if it will not start on my Faber Indoor Fireplace?
If the flame effect will not start, it might be because the transducer is not installed properly. Ensure that the connectors are inserted correctly.
Essential safety guidelines, operating precautions, and warnings for safe usage.
Outlines the necessary power supply and water supply requirements for installation.
Steps for preparing the fireplace unit by removing the front glass panel.
Suggested framing options and guidelines for the FEF3226L1 model installation.
Guides on positioning the fireplace into the opening and installing the control box.
Step-by-step instructions for connecting the electrical supply to the fireplace.
Instructions for connecting all water supply components and checking for leaks.
Details the remote control functions and the process for pairing it with the fireplace.
Lists common symptoms, their causes, and recommended actions for troubleshooting.
General| Model | e-MatriX 800 |
|---|---|
| Category | Indoor Fireplace |
| Fuel Type | Electric |
| Viewing Area Width | 800 mm |
| Control | Remote Control |
| Adjustable Flame | Yes |
| Adjustable Fuel Bed | Yes |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Thermostat | Yes |
| Remote Control | Yes |
| Timer | Yes |
| Color | Black |
| Fuel Bed | LED |
| Power | 2000 W |
| Flame Effect | 3D |
| Safety Features | Overheat Protection |
To Next Page
