Fac C3 - Page 30

28
180°
x2
x1
x1
Fig. 14
5
8
Fig. 13Fig. 12
EN
MAINTENANCE
7 .2 - Blades replacement
• In order to obtain good performance, the blades must be
well-sharpened. If necessary, the manufacturer recommends
replacementoftheentireunitinordertopreventcouplingproblems
ofthebladesandconsequentmalfunctioningofthesame.
Only for personnel authorized by the manufacturer
• Toreplaceorsharpentheblades:
a. Wear cut-proof gloves
b. Openthecover(6)(Fig.10).
c. Removethebladesunit(8)fromthepot(5)(Fig.12).
d. Useavice(x1)withprotectivejaws(x2)soasnottodamagetheTeon
partsofthebladesunit(Fig.13).
e. Fixthebladesunit,
 rotatedby180°,
 intothevice(x1).
7.2 -