Fac C3 - Troubleshooting

33
EN
PROBLEM CAUSES SOLUTION
Theappliancedoesn’tstart.
Mainswitchturnedoff. Turnonthemainswitch.
Lack of voltage on the
powersupplyline.
Please contact the retailer
oranauthorizedassistance
centre.
The pot has not been
insertedcorrectly.
Checkthecorrectinsertion
ofthepot.
Thepotcoverisnotclosed
correctly.
Checkthecorrectclosureof
thecover.
Thedirectionofrotationof
thetoolisnotcorrect.
The equipment power
supply phases cables are
notconnectedcorrectly.
Let the power cables
inversion be performed by
aqualiedtechnician.
For“C5” and “C8” models with speed changer only
The indicator light ashes
and/or the appliance does
notfunction.
The safety devices have
intervened.
•Checkthepotis inserted
correctlyand/orthecover
isclosedcorrectly.
•Pressthestopbuttonand
re-starttheappliance.
TROUBLESHOOTING
• Thefollowinginformationisintendedtoaidinidentifyingandcorrectingdefectsand
faultsthatmayoccurduringuseofthemachine.
☞
Some failures can be resolved by the user; others require
precise technical skills or special skills, and must be carried
out by qualified personnel with recognized expertise and
experience in the specific area of intervention.
Do not disassemble the inner parts of the cutter. The manufacturer
declines all responsibility for any damage caused by tampering.