Fac C3 - Decommissioning the Cutter

32
EN
DECOMMISSIONING THE CUTTER
11 .1 - Correct procedure
Amachinecompromises:
• Aluminium-alloyframe.
• Stainless-steelinsertsandcomponents.
• Electricalpartsandelectricalcables.
• Electricalmotor
• Plastics,etc.
- When commissioning third parties to perform dismantling and demolition, only
businessesauthorisedtodisposeofthesematerialsshouldbeemployed.
- Whendemolishingwithoutoutsideassistance,sortthevarioustypesofmaterialand
handovertoauthorisedbusinessesfordisposal..
ALWAYS comply with the current legislation of the country in which the
slicer is utilised.
☞
CAUTION: ALWAYS consult the manufacturer or after-sales
assistance staff authorised by the former in order to remove the
blades and dispose of the same, so that this can be performed
without constituting a hazard.
DO NOT ABANDON SCRAPS AS THEY ARE A SERIOUS
DANGER FOR PEOPLE, ESPECIALLY CHILDREN, AND
ANIMALS.
--------------------------
Refer to the “Instructions for treatment at the end of life” on page 12.