Page ii of ii
CNC 8055 / CNC 8055i
N
EW
F
EATURES
Version 7.11
1 Detected errors ................................................................................................................43
2 New validation codes .......................................................................................................46
3 Smooth stop in probing move (G75/G76) ........................................................................46
4 Square-corner or round-corner machining when changing tool offset .............................46
5 New management of the distance-coded reference mark (I0) .........................................47
6 Improved look ahead ........................................................................................................47
7 Leadscrew error compensation in both directions ............................................................47
8 Parameters accessible from the oscilloscope or OEM subroutine ...................................48
8.1 Axis parameters that may be modified from the oscilloscope ...................................48
8.2 General parameters modifiable from the oscilloscope ..............................................48
8.3 Machine parameters modifiable from an OEM program ...........................................48
To Next Page
Loading...
Need help?
General
