N
EW
F
EATURES
(S
OFT
M: 7.
XX
)
Page 3 of 50
CNC 8055 / CNC 8055i
Management of the
new Sercos board
4 Management of the new Sercos board
This software version is ready to work with the new Sercos boards,
reference: 902103 and newer.
The "Hardware diagnosis" function shows these boards as
"SERCOS816" because they carry the SERCON 816 chip.
5 Key inhibiting codes for the monitors
The inhibiting codes for softkeys F1 through F7 of monitors models
such as “NMON-55-11-LCD” are:
6 New work languages
Basque and Russian are now available from this version on.
LANGUAGE (P122)
Defines the work language
7 Load version without using an external microprocessor.
This feature is available on the 8055i CNC models whose
identification label shows "03a" or later and on 8055 CNC models
whose CPU label shows "32a" or later. Besides, their software
version must be V7.01 or later.
It is not necessary to turn the CNC off and back on or actuate the
external switch to update the software version, as indicated in
section 2.2 of the Operating Manual.
To update the CNC software, proceed as follows:
•
Remove the "Memkey Card" and insert the "Memory Card" that
contains the software version to be updated.
•
Access the Diagnosis mode - Software Configuration and press
the [Load version] softkey.
The CNC will show the software updating stages and their status.
•
When done updating it, remove the "Memory Card" that contains
the software version and insert the "Memkey Card" back.
F1 F2 F3 F4 F5 F6 F7
Bit 24
R508
Bit 25
R508
Bit 26
R508
Bit 27
R508
Bit 28
R508
Bit 29
R508
Bit 30
R508
Possible values:
0 English 1 Spanish 2 French
3 Italian 4 German 5 Dutch
6 Portuguese 7 Czech 8 Polish
9 Mainland Chinese 10 Basque 11
Russian
By default 0
Note:
• If the "[load version]" softkey is pressed but the Memory
Card containing the software version is missing, the CNC
will issue the relevant error message.
• The CNC cannot execute anything if it has the Memory
Card that contains the software version.
To Next Page
Loading...
Need help?
General
