NEW FEATURES
(SOFT M: 9.0X)
CNC 8055 / CNC 8055i
Page 14 of 106
3 Telediagnosis
3.1 Disable the CNC screen and keyboard from the PC
The CNC screen and keyboard may be disabled from the WinDNC so
the user cannot manipulate the CNC while telediagnosis is running.
When the keyboard is disabled, neither the feedrate override nor the
CYCLE STOP button are disabled. These operations are carried out
by activating and deactivating the corresponding icons on the left side
of the telediagnosis screen.
3.2 Telephone call from the CNC
A screen will come up at the CNC for dialing a telephone number
through a modem. This screen is accessed from "DNC status", by
pressing the "telephone call" softkey.
The screen allows entering a telephone number indicating the line
access, country code, number and extension.
If the "telephone number" field has already a value, it is possible to
make a call by selecting the telephone icon and pressing [ENTER] or
by pressing the "Call" softkey. Likewise, to pick it up, it may be done
using the icon or the "pick up" softkey.
It is also possible to select the call by pulses or by tones by selecting
the corresponding window.
The bottom of the screen shows the warning and error messages that
come up.
To establish connection, the WinDNC of the PC must be in the new
call waiting mode.
Telephone
Extension
Country
Line access
DIALUP
TONES
To Next Page
Loading...
