Fagor CNC 8065 - Electrical Characteristics of the Inputs and Outputs

Remote modules
CNC 8060
CNC 8065
6.
(REF: 1402)
·111·
REMOTE MODULE RIOR. (CANOPEN PROTOCOL).
6.3 Electrical characteristics of the inputs and outputs.
Digital inputs.
The digital inputs have no galvanic isolation. Each connector has an auxiliary 24 V output
protected against short-circuits, to feed the digital inputs. The digital inputs have the following
characteristics.
Digital outputs.
The digital outputs have no galvanic isolation. The digital outputs have the following
characteristics.
Nominal voltage. +24 V DC (between +20 V DC and +28 V DC).
High threshold "1". Over +20 V DC.
Low threshold "0". Under +5 V DC.
Typical consumption of each input. 3.5 mA.
Maximum consumption of each input. 4 mA.
Nominal voltage. +24 V DC (between +20 V DC and +28 V DC).
Maximum supply voltage. +36 V DC.
Output voltage. 1 V less than the supply voltage.
Maximum output current. 300 mA per output.
Maximum output inductance. 1 H.