Remote modules
CNC 8060
CNC 8065
7.
(REF: 1402)
·125·
REMOTE MODULE RCS-S. (SERCOS PROTOCOL)
7.5 Feedback cable characteristics.
We recommend to run the feedback cables as far away as possible from the power cables
of the machine.
Use shielded cables connecting the shields to the ground plate inside the electrical cabinet.
The unshielded portion of the wires of an unshielded cable cannot be longer than 75 mm.
Fagor Automation offers a wide range of cables and extension cables to connect the feedback systems
to the CNC. The cable characteristics , as well as its length, depend on the type of feedback being used.
Refer to our catalog for further information.
Always connect the shield of the feedback cable to the ground plate of the electrical cabinet using a
metallic clamp. Fagor shall not be held responsible for any system malfunction if this connection is not
made.
Ground plate.
Cable shield.
Feedback cable.
To Next Page
Loading...
