Remote modules
CNC 8060
CNC 8065
7.
(REF: 1402)
·133·
REMOTE MODULE RCS-S. (SERCOS PROTOCOL)
Find folder.
Loading software (from the PC to the remote module "RCS-S").
Once all the steps have been completed, click on the "OK" button to start the software loading
process from the PC to the remote module "RCS-S".
CONFIGURATIONS
Default Boot.
SetUp> Preferences> Boot
Use this menu sequence to set the "Default Boot Type" and also uncheck the option "Ask
for boot type".
Click on this icon to go to the "Version folder" window where the version to be installed has
been decompressed (expanded). Locate and select the file "cser2.cfg" in the corresponding
folder and click on the Open button.
Click on this icon to go to the "instructions" text window. Proceed by following all the steps
indicated next.
Note. The buttons mentioned by the text in this window are located on the front panel of the
of the remote module "RCS-S".
To Next Page
Loading...
