·26·
Remote modules
CNC 8060
CNC 8065
3.
(REF: 1402)
RIO70 REMOTE MODULES. (CANFAGOR PROTOCOL).
Fagor supplies all types of possible combinations with half-size modules, even units with a
single half-size module (the other half will be a cover). The available modules are the
following.
• Power supply.
The power supply module must be present in each group. This module must be powered
at 24 V DC and connected to the system CAN bus.
• Feedback inputs.
Each module has 4 feedback inputs.
• Digital inputs. Half size.
Each module has 16 digital inputs.
• Digital outputs. Half size.
Each module has 16 digital outputs.
• Analog inputs. Half size.
Each module has 8 analog inputs.
• Analog outputs. Half size.
Each module has 4 analog outputs.
Protection and power supply of the modules.
Class III safety protection unit, DCVA that must be powered with a SELV power supply.
Probe connection.
The digital inputs let you handle the signal of the two 24 V DC probes . Use machine
parameters to define which digital input is associated with each probe and their type of pulse.
To Next Page
Loading...
