Remote modules
CNC 8060
CNC 8065
3.
(REF: 1402)
·41·
RIO70 REMOTE MODULES. (CANFAGOR PROTOCOL).
Feedback cable characteristics.
The cable used must have overall shield; the rest of the characteristics of the cable, as well
as its length, will depend on the type of feedback device used. Refer to our catalog.
The shield of the cable being used must be connected to the connector housing at both ends.
The unshielded portion of the wires of an unshielded cable cannot be longer than 75 mm.
We recommend to run the feedback cables as far away as possible from the power cables
of the machine.
Fagor Automation offers a wide range of cables and extension cables to connect the feedback systems
to the CNC. Refer to our catalog for further information.
To Next Page
Loading...
