Remote modules
CNC 8060
CNC 8065
3.
(REF: 1402)
·43·
RIO70 REMOTE MODULES. (CANFAGOR PROTOCOL).
Numbering by machine parameters.
When the numbering is set by machine parameters, each module is assigned a base index
and the inputs or outputs of that module are numbered after it. The values of the base index
must be comply with the formula 16n+1 (i.e. 1, 17, 33, etc.). The rest of the inputs or outputs
are numbered sequentially. The base indexes may follow any order, they do not have to be
sequential.
When inserting a new module, the first modules will be assigned the numbering of the table
and the last one will be assigned the next valid base index after the highest one assigned
until then.
Examples for numbering the different modules.
Remote group (1).
Digital inputs. Digital outputs.
Base index. Numbering. Base index. Numbering.
Module 1. 1 1 ·· 16 33 33 ·· 48
Module 2. 33 33 ·· 48 81 81 ·· 96
Module 3. 97 97 ·· 112
Remote group (2).
Digital inputs. Digital outputs.
Base index. Numbering. Base index. Numbering.
Module 1. 113 113 ·· 128 49 49 ·· 64
GROUP = 1
POWER SUPLY
DIGITAL OUTPUT
DIGITAL INPUTDIGITAL INPUT
O48
DIGITAL OUTPUT
O33
O96
O81
DIGITAL INPUT
I112
I97
I16
I1
I48
I33
GROUP = 2
POWER SUPLY
DIGITAL OUTPUT
O64
DIGITAL INPUT
O49
I128
I113
To Next Page
Loading...
