Hardware configuration
CNC 8065
10.
(REF: 1404)
·101·
BUS CAN (CANFAGOR/CANOPEN PROTOCOLS).
10.2 Type of CAN bus and baudrate.
Bus type selector: CANfagor / CANopen.
The CNC has two types CAN bus: CANfagor and CANopen. There are specific remote
modules for each type of bus; at the CNC and at the operator panels, the type of active CAN
bus must be selected.
Bus type selection at the operator panels and keyboards.
Switch ·1· (CAN F/O) selects the type of CAN bus to by used, i.e. CANfagor or CANOpen.
Bus type selection at the CNC.
At the CNC, the type of CAN bus is selected by means of the machine parameters (parameter
CANMODE),
·CAN F/O· Type of CAN bus.
OFF The CANfagor bus has been selected.
ON The CANopen bus has been selected.
123
4
ON
CAN F/O
CO BR
ADD MSB
To Next Page
Loading...
