Fagor CNC 8065 - CPU Board

·50·
Hardware configuration
CNC 8065
4.
(REF: 1404)
CENTRAL UNIT ICU.
4.4.3 CPU board.
CHASSIS
+24Vdc
LATCH
F5A
CHASSIS
GND
+24Vdc
(out)
Vch-
Vch+
Chassis
Vbat+
Vbat-
BATTERY
GND
(in)
·BATTERY· connector .
Connecting the emergency battery for voltage supply and
charging it.
Ground connection.
Auxiliary 24 V DC output.
Auxiliary 24V output to supply the operator panel.
Protection fuse.
Fuse for protection against over-voltage (higher than 36 V
DC or 25 V AC).
·LATCH· button and status LED.
This button may be used to reactivate the power supply
after an over-current.
24 V DC voltage supply.
Voltage supply for the central unit.