·34·
Hardware configuration
CNC 8065
4.
(REF: 1404)
CENTRAL UNIT ICU.
4 CENTRAL UNIT ICU.
General characteristics. ICU central unit.
Processor. Pentium M 1.1 GHz
RAM memory. Minimum 512 Mb
RAM memory with battery. Yes
Hard disk. 4 GB compact flash.
Optional mechanical hard disk.
Monitor. LCD 10" / LCD 15" / LCD 15" TOUCH
Battery of the CMOS. CR2450 / CN371 (depending on CNC model)
(may be accessed from the outside)
Communications/connection. ICU central unit.
Ethernet. T base 10/100
USB. 2 USB 2.0 channels
Serial port. 1 RS232 / RS422 / RS485 (115 Kbaud) serial line
CAN bus. Communication with the remote modules.
Sercos Bus. Communication with Fagor drives.
Mechatrolink bus. Communication with Mechatrolink devices
(servos and inverters).
Standard peripherals. PC-compatible keyboard.
Mouse with PS-2 connector.
Video output. 1 VGA output
Inputs/outputs. ICU central unit.
Digital inputs/outputs. 8 digital inputs.
8 digital inputs or outputs (configurable).
Feedback inputs. 2 feedback inputs (TTL, differential TTL)
Emergency relay. 1 relay with two normally open contacts (1A at 24V).
Probe inputs. 2 probes (5 V or 24 V)
To Next Page
Loading...
