Fagor CNC 8065 - Page 73

Hardware configuration
CNC 8065
5.
(REF: 1404)
·73·
LCD-15SVGA. PASSIVE MONITOR " LCD15-SVGA".
Ground connection.
Remember that the ground terminals of all the elements making up the system must be
connected to a single ground point.
VGA input.
15-pin female SUB-D HD type connector.
Universal power supply for 24 VAC and 1.5 A.
3-pin male Phoenix combicom contact (7.62 mm pitch).
Softkeys.
Connection of the softkeys of the monitor to the keyboard. Maximum cable length is 1 meter.
Pin. Signal.
1RED
2 GREEN
3BLUE
4- - -
5GND
6 GND_RED
7 GND_GREEN
8 GND_BLUE
Pin. Signal.
9- - -
10 GND_SYNC
11 - - -
12 - - -
13 HSYNC
14 VSYNC
15 - - -
5
1
10
6
15
11
Signal. Function.
Ground.
0 V 0 V reference signal.
+24 V Power supply.
321
+24 V
0 V