Fagor CNC 8065 - Page 87

Hardware configuration
CNC 8065
8.
(REF: 1404)
·87·
OP-PANEL MODULE. OPERATOR PANEL WITH OR WITHOUT
SPINDLE SPEED OVERRIDE SELECTOR.
8 OP-PANEL MODULE. OPERATOR PANEL WITH OR
WITHOUT SPINDLE SPEED OVERRIDE SELECTOR.
Independent operator panel with the possibility to connect up to three electronic handwheels.
General characteristics.
Power supply. 24 Vdc universal power supply.
Connection. Connection to the central unit through CAN bus.
Handwheels. To connect three handwheels with A and B signals (5 V DC TTL).
Degree of protection. It meets the protection standard IP 65.
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
4
2
0
CNC
OFF
X+
X-
Y+ Z+
Y- Z-
4+ 5+ 6+
4- 5- 6-
7+ 7-
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
4
2
0
FEED
_
+
ZERO SINGLE RESET
SPEE D
1000 0
1000
100
10
1
100
10
1
jog
The machine manufacturer must comply with the EN 60204-1 (IEC-204-1) regulation regarding
electrical shocks in case of defective input/output pins with external power supply when not plugging
the connector before turning the power supply on.